Grass Valley DD10 part 3 User Manual

Page 9

4.1 EXTRA panel

Diamond digital DD10

229

4.1.4

ENABLING AND DISABLING BANK MODE

The Bank mode in the EXTRA panel permits access to a stored snapshot or time-
line with a single key (hotkey). The bank number is the tens digit of the register. The
hotkeys are the units digits of the register. The Bank mode may be enabled during
storing but this does not have any particular benefit.

Hold the Bank key down and select the desired bank with the numeric keypad. The
Bank key lights up. In the display a ”B” appears before the register number.

Example:

S N A P

B 0 5

S 0 0 5 – – – –

Press the lighting Bank key.

4.1.5

SELECTING A REGISTER DURING STORING

During the storing of snapshots or timelines the register to be used for storage must
be selected. The procedure is the same for both cases.
However, the indication in the display differs.

for snapshots

STOR

for Timelines

EDIT

•

If the register number is to be taken over that was shown before the actuation
of the Store or Edit key, no further selection is necessary.

Note:

In storing, the contents of the register may be overwritten,
assuming that the logged-in USER has stored in the register.

•

With the FREE key the next unassigned register can be selected.

•

By entering a one– or two–digit number in the numeric key pad and confirming
with Enter, any register may be selected. An incorrect entry can be cancelled
by pressing Clear.