Grass Valley DD10 part 3 - Manual (Page 110)

5. Application Notes Diamond digital DD10
330
Program the Timeline:
The fastest approach will be to do this via EXTRA-Number block
– Push ”Edit” in Number block, type in two ”Digits” for a free Register space and
hit ”Enter”.
– Push ”Store”.
NOTE: This stores the 1st Keyframe with DSKs being ”off”.
– ”Cut” the needed DSK ”on” in the DSK module.
– Push ”Store” again.
NOTE: This stores the 2nd Keyframe with DSKs keyed ”on”.
– Push ”Edit” again to invoke interpolation calculation and complete
the programing.
5.4.4 RUN THE DSK-TIMELINE
Prepare and use the ”EXTRA-DSK” Fader
– Type the ”two digit” Timeline number in the Number block and hit ”Enter”.
– Select ”FlipFlop” control button in order to alternately key-in
and -out the programmed DSK.
– Select ”STATUS” Display menu and activate the ”FADER-
EXTRA” (–> highlighted).
NOTE: Whenever the EXTRA Fader (or another one) shows no response,
look at this point first and make sure that the appropriate fader is acti-
vated. In turn, whenever you don’t need the EXTRA Fader, turn it off
to avoid confusion when starting to run a currently selected timeline
by touching the fader unintendedly.
– Now you can run the DSK-Transition manually.
– or –
– Use the ”Cut” and ”Auto” buttons in the EXTRA section.
Of course the Auto-Trans-Time must then be preadjusted in the EXTRA section
as well.