Grass Valley DD10 part 3 User Manual
Page 109

5. Application Notes
Diamond digital DD10
329
5.4
DOWNSTREAM KEYING WITH DEDICATED FADER
5.4.1
APPLICATION
Sometimes it is wished not only to ”cut” in a DSK or to do an ”Auto-Transition”. In
many cases the operator wants to have manual control for the DSK-Transition.
Since there is no dedicated Fader-Bar to accomplish this, there is no chance to
achieve that goal on a DD5 or DD10 panel. But on the DD20 or DD30 panel the
situation is different.
Here you have an ”EXTRA”-Fader that could be programmed to do that task.
5.4.2
PROBLEM SOLUTION
The solution is: Program a Timeline that consists of two Keyframes:
Keyframe 1 with ”DSK = off” and
Keyframe 2 with ”DSK = on”.
5.4.3
SET UP THE TIMELINE
Before such a timeline is stored it is recommended that the to be allocated memory
space is reduced as far as possible and no other settings than Transition com-
mands will get stored.
NOTE:
If, for instance, a complete ME-setup will be stored, then running such
a timeline will overwrite the manually set PP-Crosspoints according
to those that were selected during programming!
If the DSK-Keyer parameters should remain the same all the time (i.
e. always the same Station.
Logo has to be cut in) then the appropriate DEFINE MEMO area
(DSK+MASKi) has to be included when editing/storing a Timeline!
Select ”PP” in the DEFINE MEMO / RELOCATION area near the EXTRA number
block on the panel.
Adjust the Keyer Parameters to your needs.
Step to the \ EXTRA \ DEFINE MEMO Display menu and select the ”TRANSI” field
in the upcoming configuration table. Use the arrow softbuttons to place the cursor
on the appropriate field and then push ”TOGGLE” to activate/deactivate it (activa-
ted = high-lighted). This will allow to store the TRANSITION parameters only.
If you also need to store the current settings of Keyer parameters then select the
appropriate ”DSK+MASK1” or ”DSK+MASK2” sections additionally (see NOTE
above).