Grass Valley CONTROL Center CameraMan Rev.B - Manual (Page 41)

Page 38 Installation and Operations Manual
Setting Camera Video Parameters
C.SCAN : The C. Scan mode sets the shutter speed in units of 1 H (horizontal scanning time:
63.56µs). This setting can be used to reduce horizontal noise when shooting a
computer screen.
• UP and DOWN: Used to change the shutter speed setting. Do this while
observing the picture on a video monitor.
• Range: 1/525 H. — 260/525 H.
• Default:
260/525 H.
STEP: The Step mode sets the shutter to one of the following eight speeds:
FL (flickerless), 1/125, 1/250, 1/500, 1/1000, 1/2000, 1/4000, and 1/10000 sec.
• UP: Increases the shutter speed.
• DOWN: Decreases the shutter speed.
• Default:
FL.
L EXP : The Long Exposure mode sets the shutter speed in units of 1 frame. This mode is
useful for shooting a poorly-illuminated object in a dark place.
• Range: Field mode: 1-255 FRM (frames).
Frame mode: 2-256 FRM (frames).
• UP: Increases increases the number of frames.
• DOWN: Decreases the number of frames.
• MORE: Displays Long Exposure Menu 2.
• BOOSTER: Lets you set the focus or color for subjects in poor lighting
conditions by allowing 4 frames accumulation and gain adjustment. In such
situations, turn booster ON, set the focus and color, and then turn it off. You
can then shoot in long exposure mode.
• W.EN: This function lets you change the output from the RGB/SYNC
connector on the rear panel. It is only enabled when the unit is in the Long
Exp mode.
• Sync: Outputs a composite sync signal. This is the normal setting.
• W.EN: Outputs a WEN (timing) pulse. Use this function to synchronize a
connected frame memory.
Shutter Menu (2112) Display Path: MENU > CAMERA ADJUST >SHUTTER
UP/DOWN: UP increases the shutter speed and DOWN decreses the shutter speed.
Shutter in C SCAN Mode
Shutter in STEP Mode
Shutter in L EXP Mode- menus 1 (top)
and 2 (bottom)