Grass Valley CONTROL Center CameraMan Rev.B - Manual (Page 11)

Page 8 Installation and Operations Manual
Installing Your CONTROL Center
Now that you are acquainted with your CONTROL Center’s hardware components and features, you can install it using these
procedures:
Control Unit and Switcher
1. Ensure that you have access to AC power near the Control Unit and the Switcher.
2. Choose where you want the Switcher to be located. Either:
• Rack mount the Switcher using four screws (as shown).
• Place the Switcher on a flat surface.
For skid-protection, attach the self-sticking rubber feet.
3. Place the Control Unit where desired.
4. Connect the DC power plug of the Control Unit’s power supply to the Control Unit’s DC power
port.
5. Connect the female end of the AC power cord to the Switcher’s AC power port.
6. Connect one end of the Serial cable (RS-232) to COM-2 port on the Control
Unit and the other end to the Control Unit port on the Switcher.
AC Power from
wall to switcher
RS-232 connection
between control
unit and switcher.
DC Power from
control unit to wall
Switcher rack mounted
using four screws (not
provided).