H3C Technologies H3C SecCenter UTM Manager - Manual (Page 80)

72
Figure 65 Add users to the monitored users list
Table 63 Configuration items for adding users to the monitored users list
Item Description
Device Group
Required
Select the device group to which the users belong.
Segment
Required
Enter the start and end IP addresses of the users’ network segment.
NOTE:
To place the realtime traffic monitoring configuration into effect, you must select the Enable user
monitoring policy deployment and Enable automatic policy deployment options on the page System >
System Config > Service Parameters.
Service traffic trend of a single user
The service statistics trend report collects application statistics of a single user, and displays trend graphs
of different levels.
From the navigation tree of the bandwidth management component, select Service Traffic Trend under
Analysis by User to enter the level-1 service traffic trend report page, as shown in Figure 66 . On this page,
you can do the following:
• Select the link of a service type in the Service Traffic Summary list to enter the level-2 service traffic
trend report of the service type, as shown in
Figure 67 .
• Further select a service type to enter the traffic statistics report page of the service, as shown in
Figure 68 .
• Click the icon to export reports.
Table 64 describes the service trend query options on the service traffic statistics report pages for a single
user.
Level-1 service traffic statistics of a single user
The report page of level-1 service traffic statistics for a single user is divided into three areas:
• The upper area displays the service traffic trend graphs for the upstream, downstream, and streams
of both directions.
• The middle area lists the service traffic summary, and you can click a service type link to enter the
level-2 service traffic statistics report page of the service type.
• The lower area lists the integral point traffic statistics.