H3C Technologies H3C SecCenter UTM Manager - Manual (Page 27)

19
Item Description
Select access template
Specify access parameters
Required. Select either of them.
• If you select Select access template, select a template from the
dropdown list. By default, the template named default is selected.
• If you select Specify access parameters, specify the access
parameters.
Web Username
Required
Specify the username for managing the device through web.
The username can comprise up to 20 characters.
Web Password
Required
Specify the password for managing the device through web.
IMPORTANT:
The strength of the password must meet the password strength
requirements of the device.
Web Port
Optional
Specify the port of the device providing web access service.
The port number must be an integer in the range from 0 to 65534.
Telnet Username
Optional
Specify the username for telnetting to the device.
The username can comprise up to 20 characters.
Telnet Password
Optional
Specify the password for telnetting to the device.
IMPORTANT:
The strength of the password must meet the password strength
requirements of the device.
SNMP Version
Required
Select a version, which can be SNMPv1, SNMPv2C, or SNMPv3.
Community String For Reading
Required when the SNMP version is SNMPv1 or SNMPv2C.
Specify the SNMP read community string to be used for communication
with the device.
The string can comprise up to 20 characters.
Community String For Writing
Required when the SNMP version is SNMPv1 or SNMPv2C.
Specify the SNMP write community string to be used for communication
with the device.
The string can comprise up to 20 characters.
Authentication Username
Required when SNMP version is SNMPv3.
Type the username for authentication.
Authentication Protocol
Required when SNMP version is SNMPv3.
Select a protocol for authentication.
Multi-Card Device
Optional
Type the IP addresses of interface cards that are on the device. The IP
address must be in dotted decimal notation.