H3C Technologies H3C SecPath F5000-A5 Firewall - Manual (Page 36)

26
To connect a fiber port to a peer device through optical fibers:
1. Remove the dust plug from the fiber port.
2. Remove the dust cover from the transceiver module, and plug the end without a pull latch into the
SFP port.
3. Remove the dust cover from the fiber connector.
4. Identify the Rx and Tx ports. Plug the LC connector at one end of one fiber cable into the Rx port
of the firewall and the LC connector at the other end into the Tx port of the peer device. Plug the LC
connector at one end of another fiber cable into the Tx port of the firewall and the LC connector at
the other end to the Rx port of the peer device.
Figure 22 Connecting the fiber port
5. View the LINK LED after connection.
For more information about LEDs, see "
Appendix B LEDs ."
Connecting a power cord
Connecting an AC power cord
1. Make sure the power is OFF.
2. Make sure the firewall is correctly grounded.