H3C Technologies H3C LSWM1WCM10 Access Controller Module - Manual (Page 40)

33
Now that the serial port baud rate of the access controller module has been changed to 115,200 bps
while that of the terminal is still 9,600 bps, the access controller module and the terminal cannot
communicate with each other. For this reason, you need to change the baud rate to 115,200 bps in
HyperTerminal.
Disconnect the terminal connection in HyperTerminal, as shown below:
Figure 18 Disconnect the terminal connection
1. Choose File > Properties. In the Properties dialog box, click Configure… and select 115,200 in the
Bits per second drop-down list box.
Figure 19 Modify the baud rate
2. Select Call > Call to reestablish the call connection.