H3C Technologies H3C LSWM1WCM10 Access Controller Module - Manual (Page 10)

3
Software upgrade through the web interface
NOTE:
•
This chapter takes software upgrade of access controller module LSQM1WCMB0 on an S7500E switch
and LSWM1WCM20 on an S5800 switch as examples. Unless otherwise specified, the software
upgrade procedures of all access controller modules are the same.
• You can log in to an access controller module through the console port of the module or redirect to the
module from a switch. If an access controller module does not have a console port, you can only redirect
to it from a switch.
• The display of web interface varies with device models.
The web-based network management function allows an administrator to conveniently manage and
maintain network devices through the web interface.
Setting up a web-based configuration environment
1. Set up a web-based network management environment as shown in Figure 1 .
Set up the web-based configuration environment by using one of the following two network connection
methods:
• Connect the Ethernet port of the switch to the PC with an Ethernet cable and ensure that a route from
the PC to the access controller module is active.
• Connect the management Ethernet port of the access controller module to the PC and ensure a route
from the PC to the access controller module is active.
As these two upgrade methods are similar, this document describes only the first method.
Figure 1 Set up a web-based configuration environment
2. Configure the switch
• Configuration on an S7500E switch with access controller module LSQM1WCMB0
# Configure interface Ten-GigabitEthernet 2/0/1 that connects the switch and LSQM1WCMB0 as a
trunk port and to permit all VLANs. In this example, LSQM1WCMB0 is inserted in slot 2.
[S7500]interface ten-gigabitethernet2/0/1
[S7500-Ten-GigabitEthernet2/0/1]port link-type trunk
[S7500-Ten-GigabitEthernet2/0/1]port trunk permit vlan all
[S7500]quit