H3C Technologies H3C LSWM1WCM10 Access Controller Module User Manual

Page 37

..........................................................................

...........................Done!

Select 0 to return to the BootWare main menu. Select 1 in the BootWare main menu to reboot the
system.

NOTE:
•

If the downloaded file has the same file name with an existing file in the CF card, the system prompts The
file is exist, will you recover it? [Y/N]. If you choose Y, the existing file will be replaced.

•

Make sure that sufficient space is available in the storage device. In case of insufficient space, the system
will give a prompt message.

•

The new application file directly replaces the existing file of the same type. In this example, the
downloaded file main.bin replaces the existing application file of the type M and becomes the only
main application file.

•

For more information about the application file types, see “

Appendix Introduction to software

maintenance

.”

Upgrading an application program through FTP in

BootWare menu

Set up a software upgrade environment

Figure 17 Set up an FTP upgrade environment

Connect the management Ethernet port on the access controller module to the PC with an Ethernet cable.
Run the FTP server program on the PC, and specify the path of the program to be downloaded, and

configure the FTP username as guest and password as 123456.

Modify the Ethernet port parameters.

Select 3 in the BootWare main menu to enter the Ethernet port submenu. Then, select 5 to enter the

Ethernet port configuration submenu:

==================================================

|Note: '.' = Clear field. |

| '-' = Go to previous field. |

| Ctrl+D = Quit. |

==========================================================================

Protocol (FTP or TFTP) : ftp

This manual is related to the following products:

H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module