H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 95)

87
Step Command Remarks
2. Create a remote source
group.
mirroring-group group-id remote-source
By default, no remote source
group exists on a device.
Configuring source ports for a remote source group
CAUTION:
Do not assign a source port to the remote probe VLAN.
Either you can configure a list of source ports for a mirroring group in system view, or you can assign only
the current port to the a mirroring group as a source port in interface view. To assign multiple ports to the
mirroring group as source ports in interface view, repeat the step.
When you configure source ports for the remote source group, follow these guidelines:
• A mirroring group can contain multiple source ports.
• On the WX5540E switching engine, one mirroring resource is used for mirroring unidirectional
traffic on a source port and two mirroring resources are used for mirroring bidirectional traffic on a
source port. A source port on the WX5540E switching engine is assigned a maximum of four
mirroring resources. Therefore, a port, when serving as a unidirectional source port, can be added
to up to four mirroring groups. When serving as a bidirectional port can be added to up to two
mirroring groups, and when serving as a bidirectional source port and two unidirectional ports can
be added to up to three mirroring groups.
To configure source ports for a remote source group in system view:
Step Command Remarks
1. Enter system view. system-view N/A
2. Configure source ports for a
remote source group.
mirroring-group group-id
mirroring-port mirroring-port-list
{ both | inbound | outbound } By default, no source port is
configured for a remote source
group.
To configure a source port for a remote source group in interface view:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure the current port as
a source port for a remote
source group.
[ mirroring-group group-id ]
mirroring-port { both | inbound |
outbound }
By default, a port does not serve as
a source port for any remote
source group.
Configuring source CPUs for a remote source group
Step Command Remarks
1. Enter system view. system-view N/A
2. Configure source
CPUs for a remote
source group.
mirroring-group group-id
mirroring-cpu slot slot-number-list
{ both | inbound | outbound }
By default, no source CPU is
configured for a remote source group.