H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 47)

39
System information formats
The following shows the original format of system information, which might be different from what you see.
The actual format depends on the log resolution tool you use.
Formats
The system information formats vary with output destionations. See Table 4 .
Table 4 System information formats
Output destination Format Example
Console, monitor
terminal, logbuffer,
trapbuffer, SNMP
module, or log file
timestamp sysname
module/level/digest: content %Jun 26 17:08:35:809 2013 Sysname
SHELL/4/LOGIN: VTY login from 1.1.1.1
Log host
• H3C format:
timestamp
Sysname %%vvmodule/level
/digest: source content
• UNICOM format:
timestamp Sysname
vvmodule/level/serial_numb
er: content
• H3C format:
<189>Oct 9 14:59:04 2012
Sysname %%10SHELL/5/SHELL_LOGIN(l):
VTY logged in from 192.168.1.21
• UNICOM format:
{
<186>Oct 13 16:48:08 2012 Sysname
10IFNET/2/210231a64jx073000020:
log_type=port;content=Vlan-interface1
link status is DOWN.
{
<186>Oct 13 16:48:08 2012 Sysname
10IFNET/2/210231a64jx073000020:
log_type=port;content=Line protocol on
the interface Vlan-interface1 is DOWN.
Field description
Field Description
PRI (priority)
The priority is calculated by using this formula: facility*8+level, where:
• facility is the facility name. It can be configured with info-center loghost. It is
used to identify different log sources on the log host, and to query and filter logs
from specific log sources.
• level ranges from 0 to 7. Table 1 describes details the severity levels.
Note that the priority field is available only for information that is sent to the log
host.
Timestamp
The timestamp records the time when the log was generated.
Logs sent to the log host and those sent to the other destinations have different
precisions, and their timestamp formats are configured with different commands.
For more information, see Table 5 and Table 6 .
Sysname (host name or
host IP address)
• If the system information that is sent to a log host is in the UNICOM format, and
the info-center loghost source command is configured, the sysname field is
displayed as the IP address of the device that generated the system information.
• If the system information is in the H3C format, the field is displayed as the
system name of the device that generated the system information. You can use
the sysname command to modify the local system name. For more information,
see Fundamentals Command Reference.