H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 52)

44
Step Command Remarks
2. Enable the information
center.
info-center enable
Optional.
Enabled by default.
3. Specify a name for a
channel identified by its
number.
info-center channel channel-number
name channel-name Optional.
See
Table 2 for default channel names.
4. Configure an output rule
for the log host.
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap { level
severity | state state } * ] *
Optional.
See "
Default output rules of system
information ."
5. Specify the source IP
address for the log
information.
info-center loghost source
interface-type interface-number
Optional.
By default, the source interface is the
output interface of the matching route,
and the primary IP address of the
output interface is used as the source IP
address of log information.
6. Configure the timestamp
format for system
information output to the
log host.
info-center timestamp loghost { date
| iso | no-year-date | none }
Optional.
date by default.
7. Set the system
information format.
• Set the format to UNICOM:
info-center format unicom
• Set the format to H3C:
undo info-center format
Optional.
Use either approach.
H3C by default.
8. Specify a log host and
configure related
parameters.
info-center loghost
host-ipv4-address [ port
port-number ] [ dscp dscp-value ]
[ channel { channel-number |
channel-name } | facility
local-number ] *
By default, no log host or related
parameters are specified.
If no channel is specified when
outputting system information to a log
host, the system uses channel 2
(loghost) by default.
The value of the port-number argument
must be the same as the value
configured on the log host. Otherwise,
the log host cannot receive system
information.
Outputting system information to the trap buffer
The trap buffer receives the trap information only, and discards the log and debugging information.
To output system information to the trap buffer:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable the information center. info-center enable
Optional.
Enabled by default.