beautypg.com

Configuring the multicast mode, Configuring a multicast client, Configuring the multicast server – H3C Technologies H3C WX5500E Series Access Controllers User Manual

Page 24: Configuring optional parameters, Specifying the source interface for ntp messages

background image

16

Step Command

Remarks

3.

Configure the device to

operate in NTP broadcast
server mode.

ntp-service broadcast-server
[ authentication-keyid keyid |

version number ] *

A broadcast server can
synchronize broadcast clients only
when its clock has been

synchronized.

Configuring the multicast mode

The multicast server periodically sends NTP multicast messages to multicast clients, which send replies

after receiving the messages and synchronize their local clocks.
Configure the NTP multicast mode on both the server and clients. The NTP multicast mode must be

configured in a specific interface view.

Configuring a multicast client

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter VLAN interface view.

interface interface-type
interface-number

This command enters the view of
the interface for sending NTP

multicast messages.

3.

Configure the device to

operate in NTP multicast client
mode.

ntp-service multicast-client
[ ip-address ]

N/A

Configuring the multicast server

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter VLAN interface view.

interface interface-type
interface-number

This command enters the view of
the interface for sending NTP

multicast messages.

3.

Configure the device to
operate in NTP multicast

server mode.

ntp-service multicast-server
[ ip-address ]

[ authentication-keyid keyid | ttl
ttl-number | version number ] *

A multicast server can synchronize
broadcast clients only when its

clock has been synchronized.

Configuring optional parameters

This section explains how to configure the optional parameters of NTP.

Specifying the source interface for NTP messages

If you specify the source interface for NTP messages, the device sets the source IP address of the NTP

messages as the primary IP address of the specified interface when sending the NTP messages.
When the device responds to an NTP request received, the source IP address of the NTP response is
always the IP address of the interface that received the NTP request.