H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 64)

56
Task Remarks
Configuring SNMP logging Optional.
Configuring SNMP traps Optional.
Configuring SNMP basic parameters
SNMPv3 differs from SNMPv1 and SNMPv2c in many ways. Their configuration procedures are
described in separate sections.
Configuring SNMPv3 basic parameters
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable the SNMP agent. snmp-agent
Optional.
By default, the SNMP agent is
disabled.
You can also enable the SNMP
agent by using any command that
begins with snmp-agent except the
snmp-agent calculate-password
and snmp-agent ifmib long-ifindex
enable commands.
3. Configure system information
for the SNMP agent.
snmp-agent sys-info { contact
sys-contact | location sys-location
| version { all | { v1 | v2c |
v3 }* } }
Optional.
The defaults are as follows:
• Contact—Hangzhou H3C Tech.
Co., Ltd.
• Location—Hangzhou China.
• Version—SNMPv3.
4. Configure the local engine ID. snmp-agent local-engineid
engineid
Optional.
The default local engine ID is the
company ID plus the device ID.
After you change the local engine
ID, the existing SNMPv3 users
become invalid, and you must
re-create the SNMPv3 users.