H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 70
61
NOTE:
•
Before connecting an optical fiber, make sure that the connector and
cable type match the hot swappable interface module.
•
The fiber Ethernet port of the WX3010E wireless switch supports only the
LC connector.
•
Fiber connectors are fitted with dust caps. Keep the dust caps properly
when the fiber connectors are in use. Install dust caps when the fiber
connectors are not in use to avoid damage to their end face. Replace the
dust cap if it is loose or polluted.
•
Before connecting an optical fiber, use dust free paper and absolute
alcohol to clean the end face of the two fiber connectors. You can brush
the end faces only in one direction.
•
Never bend or curve a fiber when connecting it.
•
If the fiber has to pass through a metallic board hole, when passing
through a metallic board hole or bending along the acute side of
mechanical parts, the fiber must wear jackets or cushions.