H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 28)

19
Grounding the wireless switch with the
grounding terminal on the chassis
(recommended)
To connect the grounding cable:
1. Remove the grounding screw from the rear panel of the wireless switch
chassis.
2. Attach the grounding screw to the ring terminal of the grounding cable.
3. Use a Phillips screwdriver to fasten the grounding screw into the
grounding screw hole.
4. Connect the other end of the grounding cable to the grounding screw on
the rack.
5. Install the grounding screw to the grounding hole on the chassis, and
fasten the screw.
Figure 11 Connecting the grounding cable to the grounding hole of wireless
switch
(1) Ring terminal