H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 56)

47
• reboot—The wireless switch automatically reboots to recover from the
error condition.
• maintain—The wireless switch stays in the error condition so you can
collect complete data, including error messages, for diagnosis. In this
approach, you must manually reboot the wireless switch.
To configure the exception handling method:
Step Command Remarks
1. Enter system view. system-view N/A
2. Specify the
exception handling
method.
system-failure { maintain
| reboot }
Optional.
By default, the wireless
switch reboots when an
exception occurs.
Displaying the exception handling method
Use the display system-failure command to display the exception
handling method.
display system-failure
System failure handling method: reboot
Rebooting the wireless switch
When upgrading and maintaining the system software image file, or
configuration file for the wireless switch, you must reboot the wireless
switch. To reboot a wireless switch, use one of the following methods:
• Reboot the wireless switch immediately at the CLI.
• At the CLI, schedule a reboot to occur at a specific time and date or after
a delay.
• Power off and then re-power on the wireless switch. This method might
cause data loss, and is the least preferred method.
Reboot at the CLI enables easy remote device maintenance.
To reboot the wireless switch immediately: