H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 64
55
application requirements and are expensive although they provide better
EMI prevention performance than UTPs, so in most LANs, UTPs are
commonly used.
An Ethernet twisted pair cable connects network devices through the
RJ-45 connectors at the two ends.
shows the pinouts of an RJ-45
connector.
Figure 24 RJ-45 connector pinout
NOTE:
The RJ-45 Ethernet ports of the H3C WX3010E wireless switch use
category 5 or higher Ethernet twisted pair cables for connection.
EIA/TIA cabling specifications define two standards, 568A and 568B,
for cable pinouts.
•
Standard 568A—pin 1: white/green stripe, pin 2: green solid, pin 3:
white/orange stripe, pin 4: blue solid, pin 5: white/blue stripe, pin 6:
orange solid, pin 7: white/brown stripe, pin 8: brown solid.
•
Standard 568B—pin 1: white/orange stripe, pin 2: orange solid, pin 3:
white/green stripe, pin 4: blue solid, pin 5: white/blue stripe, pin 6:
green solid, pin 7: white/brown stripe, pin 8: brown solid.
Ethernet twisted pair cables can be classified into straight-through and
crossover cables based on their pinouts.
•
Straight-through—The pinouts at both ends are T568B compliant, as
shown in
.
•
Crossover—The pinouts are T568B compliant at one end and T568A
compliant at the other end, as shown in
.
PIN #8
PIN #1