H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 60)

51
NOTE:
After reboot, the system runs with the initial default configuration, but the
original configuration file is still stored in the storage medium. To restore
the original configuration, use the display saved-configuration command
to display the configuration, and then copy and execute the configuration.
4. Save the new configuration.
save
NOTE:
•
After you modify the login password, use the save command to save it.
• Save the configuration to the default configuration file.
Software loading failure
If software loading fails, the system runs the software of the previous
version. To troubleshoot the software loading failure:
• Check whether the physical ports are correctly connected. If the cable of
any port is not connected, re-connect the cable to the port, and make
sure that the physical connection is correct. Then, perform software
loading again.
• Check for errors in the software loading process displayed on the
HyperTerminal. If errors exist, correct them, and perform software loading
again.
For example, the software loading failures may occur in the following
cases:
• When you use XMODEM to load software, you select a baud rate other
than 9600 bps, but you have not re-set the baud rate for the
HyperTerminal.
• When you use TFTP to load software, you have input an incorrect IP
address, software name, or TFTP serve path.
• When you use FTP to load software, you have input an incorrect IP
address, software name, username, or password.