H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 34)

25
Installing a transceiver module
WARNING!
When connecting an optical fiber, follow these guidelines:
• Never bend or curve a fiber when connecting it. After a fiber is installed
well, the bend radius must be not less than 10 cm (3.94 in).
• Keep the fiber end clean.
• Make sure that the fiber connector matches the transceiver module.
• Before connecting a fiber, make sure that the optical power at the
receiving end does not exceed the upper threshold of the optical receive
power of the transceiver module. Otherwise, the transceiver module may
be damaged.
To connect the wireless switch to the network through an optical fiber:
1. Remove the dust plug on the fiber port.
2. Insert the transceiver module into the fiber port.
3. Remove the dust cover of the optical fiber connector, and use dust free
paper and absolute alcohol clean the end face of the fiber connector.
4. Plug one end of the optical fiber into the transceiver module in the
wireless switch, and plug the other end into the transceiver module in the
peer device.