H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 32)

23
• The installed port lighting protectors are not sufficient.
If the wireless switch has more than one network port connected with
other devices through cables outdoor, you should install a lightning
protector for each network port.
Connecting Ethernet cables
Connecting a copper Ethernet port
To connect a copper Ethernet port:
1. Connect one end of the Ethernet cable to the copper Ethernet port of the
wireless switch, and the other end to the Ethernet port of the peer device.
2. Check whether the LEDs of the Ethernet port are normal.
Table 7 LED description
LED Status Description
10/100/1000 Base-T
autosensing Ethernet
port LED
(yellow/green)
Steady green
The port is operating at 1000
Mbps.
Flashing green
The port is sending or receiving
data at 1000 Mbps.
Steady yellow
The port is operating at 10/100
Mbps.
Flashing yellow
The port is sending or receiving
data at 10/100 Mbps.
Off No link is present.
Connecting a fiber port
GE SFP transceiver module
The WX3010E wireless switch supports only GE SFP transceiver modules.