Verifying the configuration – H3C Technologies H3C MSR 50 User Manual
Page 82
73
[AP-WLAN-BSS1] quit
# Create a WLAN service template of the clear type, configure its SSID as service, and enable
open-system authentication for the WLAN service template.
[AP] wlan service-template 1 clear
[AP-wlan-st-1] ssid service
[AP-wlan-st-1] authentication-method open-system
# Configure WLAN service-based client rate limiting on AC to limit the rate of traffic from clients to AP
(incoming traffic) to 8000 kbps in static mode and the rate of traffic from AP to clients (outgoing traffic)
to 8000 kbps in dynamic mode.
[AP-wlan-st-1] client-rate-limit direction inbound mode static cir 8000
[AP-wlan-st-1] client-rate-limit direction outbound mode dynamic cir 8000
[AP-wlan-st-1] service-template enable
[AP-wlan-st-1] quit
# Bind service template 1 to WLAN-BSS 1 on interface WLAN-radio 2/0.
[AP] interface wlan-radio 2/0
[AP-WLAN-Radio2/0] radio-type dot11g
[AP-WLAN-Radio2/0] channel 1
[AP-WLAN-Radio2/0] service-template 1 interface wlan-bss 1
[AP-WLAN-Radio2/0] return
Verifying the configuration
# Use the display wlan client-rate-limit service-template command to display the client rate limiting
configuration.
Client Rate Limit
--------------------------------------------------------------------------------
Service Template Direction Mode CIR(kbps)
--------------------------------------------------------------------------------
1 Inbound Static 8000
1 Outbound Dynamic 8000
--------------------------------------------------------------------------------
1.
When only Client 1 accesses the WLAN through SSID service, the available bandwidth is limited
to around 8000 kbps.
2.
When both Client 1 and Client 2 access the WLAN through SSID service, the bandwidth available
for the traffic from either Client 1 or Client 2 to the AP is limited to around 8000 kbps, and the
bandwidth available for the traffic from the AP to either Client 1 or Client 2 is limited to around
4000 kbps.