Configuring psk authentication, Configuring 802.1x authentication, Configuring mac address authentication – H3C Technologies H3C MSR 50 User Manual
Page 50: Configuring psk and mac address authentication
41
This document describes only common port security modes. For more information about other port
security modes, see Security Configuration Guide.
Before configuring port security, create the wireless port and enable port security.
Configuring PSK authentication
Step Command
Remarks
189.
Enter system view.
system-view
N/A
190.
Enter WLAN-BSS interface
view.
interface wlan-bss
interface-number
N/A
191.
Enable 802.11 key
negotiation.
port-security tx-key-type 11key
By default, 802.11 key negotiation
is not enabled.
192.
Configure the pre-shared key.
port-security preshared-key
{ pass-phrase | raw-key } [ cipher
| simple ] key
By default, no pre-shared key is
configured.
193.
Enable the PSK port security
mode.
port-security port-mode psk
N/A
Configuring 802.1X authentication
Step Command
Remarks
194.
Enter system view.
system-view
N/A
195.
Enter WLAN-BSS interface
view.
interface wlan-bss
interface-number
N/A
196.
Enable 802.11 key
negotiation.
port-security tx-key-type 11key
By default, 802.11 key
negotiation is not enabled.
197.
Enable the 802.1X port
security mode.
port-security port-mode
userlogin-secure-ext
N/A
Configuring MAC address authentication
802.11i does not support MAC address authentication.
To configure MAC address authentication:
Step Command
198.
Enter system view.
system-view
199.
Enter WLAN-BSS interface view.
interface wlan-bss interface-number
200.
Enable MAC port security mode.
port-security port-mode mac-authentication
Configuring PSK and MAC address authentication
For more information about port security configuration commands, see Security Configuration Guide.
To configure PSK and MAC address authentication:
Step Command
Remarks
201.
Enter system view.
system-view
N/A