beautypg.com

Configuring scan parameters, Displaying and maintaining wlan rrm – H3C Technologies H3C MSR 50 User Manual

Page 41

background image

32

To configure the 802.11n protection mode:

Step Command

Remarks

146.

Enter system view.

system-view

N/A

147.

Enter WLAN RRM view.

wlan rrm

N/A

148.

Configure the 802.11n

protection mode.

dot11n protection-mode
{ cts-to-self | rts-cts }

Optional.
By default, the 802.11n protection
mode is CTS-to-Self.

Configuring scan parameters

The scan type and scan report-interval commands apply to channel adjustment, rogue device detection,
and IDS detection.
The autochannel-set avoid-dot11h command applies to all types of channel scanning.
To configure scan parameters:

Step Command

Remarks

149.

Enter system view.

system-view

N/A

150.

Enter WLAN RRM view.

wlan rrm

N/A

151.

Set the scan mode.

scan channel { auto | all }

Optional.
By default, the scan mode is auto.

152.

Set the scan type.

scan type { active | passive }

Optional.
By default, the scan type is passive.

153.

Set the scan report interval.

scan report-interval seconds

Optional.
By default, the scan report interval
is 10 seconds.

154.

Configure only non-dot11h
channels to be scanned.

autochannel-set avoid-dot11h

Optional.
By default, the default setting of the
command depends on the scan

channel command.

Displaying and maintaining WLAN RRM

Task Command

Remarks

Display WLAN RRM information.

display wlan rrm [ | { begin |
exclude | include }

regular-expression ]

Available in any view.

This manual is related to the following products: