beautypg.com

Verifying the configuration, Configuration guidelines – H3C Technologies H3C MSR 50 User Manual

Page 33

background image

24

[AP-WLAN-Radio2/0] return

Verifying the configuration

Use the display wlan client-mode radio command to display the configuration and connection status for

the workgroup bridge.

display wlan client-mode radio

WLAN Client Mode

--------------------------------------------------------------------------------

Radio : 1

Mode : 802.11g

Authentication Method : Shared-Key

Cipher Suite : WEP40

Key (Simple) : 12345

WEP Key ID : 1

SSID : China-net

BSSID : 000f-e233-5501

Status : Connected

--------------------------------------------------------------------------------

Received Packets

Data : 1324939

Management : 34876

Sent Packets

Data : 46365

Discarded Packets : 38272

Rate(Rx/Tx) : 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Online Duration : 0 days 0 hours 45 minutes 5 seconds

--------------------------------------------------------------------------------

The output shows that the AP that operates as a workgroup bridge has been successfully associated with
wireless service China-net.

Configuration guidelines

As shown in

Figure 10

, the workgroup bridge has two radio interfaces. Radio 1 connects the

workgroup bridge to the AP, and Radio 2 connects the workgroup bridge to the client. To enable the

client associated with Radio 2 to access the AP through the workgroup bridge, you need to disable

wireless user isolation by performing the wlan-client-isolation enable command on the workgroup
bridge.

Figure 10 Workgroup bridge with two radio interfaces

To configure VLAN settings for the uplink wireless interface on the workgroup bridge, make sure the
uplink wireless interface has the same VLAN ID as the downlink Ethernet interface on the

workgroup bridge.

AP

Workgroup Bridge

Client

Radio 1

Radio 2

This manual is related to the following products: