beautypg.com

Svp service configuration example – H3C Technologies H3C MSR 50 User Manual

Page 79

background image

70

SVP service configuration example

1.

Network requirements
As shown in

Figure 31

, the fat AP is connected to the Ethernet and has WMM enabled.

On the fat AP, SVP packets are assigned to the AC-VO queue. To guarantee the highest priority for
the AC-VO queue, ECWmin and ECWmax are set to 0 for the AC-VO queue.

Figure 31 Network diagram

2.

Configuration procedure
# Configure interface WLAN-BSS 1 to use the 802.11e priority of received packets for priority
mapping.

system-view

[Sysname] interface wlan-bss 1

[Sysname-WLAN-BSS1] qos trust dot11e

[Sysname-WLAN-BSS1] quit

# Configure interface Ethernet 1/0 to use the 802.1p priority of received packets for priority

mapping.

[Sysname] interface ethernet 1/0

[Sysname-Ethernet1/0] qos trust dot1p

[Sysname-Ethernet1/0] quit

# Create a clear-type WLAN service template, configure its SSID as market, configure its
authentication method as Open System, and then enable the WLAN service template.

[Sysname] wlan service-template 1 clear

[Sysname-wlan-st-1] ssid market

[Sysname-wlan-st-1] authentication-method open-system

[Sysname-wlan-st-1] service-template enable

# Configure the radio interface WLAN Radio 2/0.

[Sysname] interface wlan-radio 2/0

[Sysname-WLAN-Radio2/0] radio-type dot11g

[Sysname-WLAN-Radio2/0] service-template 1 interface wlan-bss 1

[Sysname-WLAN-Radio2/0] wmm enable

[Sysname-WLAN-Radio2/0] wmm svp map-ac ac-vo

[Sysname-WLAN-Radio2/0] wmm edca radio ac-vo ecw ecwmin 0 ecwmax 0

[Sysname-WLAN-Radio2/0] quit

IP network

L2 Switch

FAT AP

Client

This manual is related to the following products: