H3C Technologies H3C MSR 50 - Manual (Page 54)

45
# Configure AAA domain cams by referencing RADIUS scheme rad.
[Sysname] domain cams
[Sysname-isp-cams] authentication lan-access radius-scheme rad
[Sysname-isp-cams] authorization lan-access radius-scheme rad
[Sysname-isp-cams] accounting lan-access radius-scheme rad
[Sysname-isp-cams] quit
# Configure the MAC address authentication domain as cams.
[Sysname] mac-authentication domain cams
# Configure MAC address authentication user name format, using MAC addresses without hyphen as
username and password (consistent with the format on the server).
[Sysname] mac-authentication user-name-format mac-address without-hyphen
# On interface WLAN-radio 2/0, bind interface WLAN-BSS 1 to service template 1.
[Sysname] interface wlan-radio2/0
[Sysname-WLAN-Radio2/0] radio-type dot11g
[Sysname-WLAN-Radio2/0] service-template 1 interface wlan-bss 1
Configuring the RADIUS server (IMCv3)
The following takes the IMC (the IMC versions are IMC PLAT 3.20-R2602 and IMC UAM 3.60-E6102) as
an example to illustrate the basic configurations of the RADIUS server.
1. Add an access device:
a. Click the Service tab.
b. Select Access Service > Access Device from the navigation tree.
c. Click Add.
d. On the page that appears, enter 12345678 for Shared Key, add ports 1812, and 1813 for
Authentication Port and Accounting Port, respectively, select LAN Access Service for Service
Type, select H3C for Access Device Type, and select or manually add an access device with the
IP address 10.18.1.1, and click Apply.
Figure 15 Adding an access device
2. Add a service: