Configuring radio parameters – H3C Technologies H3C MSR 50 User Manual
Page 24
15
Step Command
Remarks
73.
Specify the maximum client
idle time.
wlan client idle-timeout interval
Optional.
The default is 3600 seconds.
74.
Specify the client keepalive
interval.
wlan client keep-alive interval
Optional.
By default, the client keep-alive
function is disabled.
75.
Enable the fat AP to respond
to probe requests with null
SSID.
broadcast-probe reply
Optional.
The default setting is enabled.
Configuring radio parameters
Configuring radio parameters
Step Command
Remarks
76.
Enter system view.
system-view
N/A
77.
Enter radio interface view.
interface wlan-radio
interface-number
N/A
78.
Configure a radio type.
radio-type { dot11b | dot11g
| dot11gn }
Optional.
79.
Specify a working channel for the
radio.
channel { channel-number |
auto }
Optional.
By default, auto mode is enabled.
The working channel of a radio
varies with country codes and
radio types. The channel list
depends on your device model.
80.
Specify the maximum radio
power.
max-power radio-power
Optional.
By default, the maximum radio
power varies with country codes,
channels, AP models, radio types,
and antenna types. If 802.11n is
adopted, the maximum radio
power also depends on the
bandwidth mode.
81.
Specify the type of preamble.
preamble { long | short }
Optional.
By default, the short preamble is
supported.
82.
Configure the antenna type.
antenna type type
Optional.
The default setting for the command
depends on the device model.