Planning the cabling scheme – H3C Technologies H3C S5830 Series Switches User Manual
Page 44
Figure 48 IRF fabric in ring topology
Identifying physical IRF ports on the member switches
Identify the physical IRF ports on the member switches according to your topology and connection
scheme.
shows the physical ports that can be used for IRF connection.
Table 6 Physical IRF port requirements
Switch chassis
Candidate physical IRF ports
S5830-52SC
•
2 fixed SFP+ ports on the front panel
•
2 SFP+ ports on the 10 GE SFP+ expansion interface card at the rear panel
NOTE:
You must purchase the expansion interface card separately.
S5830-106S
10 fixed SFP+ ports on the front panel
Planning the cabling scheme
Use SFP+ cables or SFP+ transceivers and fibers to connect the IRF member switches. If the IRF member
switches are far away from one another, choose the SFP+ transceiver modules with optical fibers. If the
IRF member switches are all in one equipment room, choose SFP+ cables.
lists the SFP+ transceivers and SFP+ cables available for IRF connections.
Table 7 SFP+ transceiver modules and SFP+ cables available for IRF connections
Transceiver/cable
Central
wavelength
Connector Cable
Max
transmission
distance
10 GE SFP+ transceivers
SFP-XG-SX-MM850-A 850
nm LC
50/125 μm
multi-mode
optical fiber
300 m (984.3 ft)
38