Installation methods – H3C Technologies H3C S5830 Series Switches User Manual
Page 16
Figure 11 Chassis rail and slide rail kit for the S5830-106S
(1) Chassis rail
(2) Slide rail
Installation methods
You can install the H3C S5830 Switch Series in a 19-inch rack by using mounting brackets, chassis rails,
and slide rails, as shown in
.
Figure 12 Installing an S5830 switch in a 19-inch rack
NOTE:
If a rack shelf is available, you can put the switch on the rack shelf, slide the switch to an appropriate
location, and fix the switch to the rack with the mounting brackets.
Table 4 Installing an S5830 switch in the rack
Mounting bracket
position
Installing the chassis rails and slide rails
Installing the switch
•
Rear mounting
(near the power
modules)
•
Front mounting
(near the network
ports)
•
See "
Installing the mounting brackets,
chassis rails, and grounding cable (for the
S5830-52SC)
•
See "
Installing the mounting brackets,
chassis rails, and grounding cable (for the
"
•
See "
"
•
See "
IMPORTANT:
To mount the switch steadily in a rack, you must also install slide rails and chassis rails besides the
mounting brackets.
For the minimum and maximum distances required between front and rear rack posts, see
.
10