Figure 14 – H3C Technologies H3C S5830 Series Switches User Manual
Page 18
mounting position, align the chassis rails with the screw holes at the rear of the side panels (see
).
4.
Use M4 screws (supplied with the switch) to fix the chassis rails to the chassis.
Attach the mounting brackets and chassis rails to both sides of the chassis in the same way.
Connecting the grounding cable to the switch chassis
CAUTION:
The primary grounding point and auxiliary grounding point are located on the left side panel. If you use
either of the grounding points, you must connect the grounding cable to the grounding point before you
mount the switch in the rack.
To connect the grounding cable to a chassis grounding point, for example, the primary grounding point:
1.
Select a grounding point.
2.
Remove the grounding screws from the primary grounding point. (You can use the screws for
connecting to the primary grounding point or the auxiliary grounding point.)
3.
Align the two-hole grounding lug at one end of the cable with the grounding holes of the
grounding point, insert the grounding screws into the holes, and tighten the screws with a
screwdriver to fix the grounding lug to the chassis, as shown in
Figure 14 Attaching the rear mounting brackets, chassis rails, and the grounding cable to the chassis
12