beautypg.com

Grounding the switch, Grounding the switch with a grounding strip – H3C Technologies H3C S5830 Series Switches User Manual

Page 26

background image

Grounding the switch

WARNING!

Correctly connecting the switch grounding cable is crucial to lightning protection and EMI protection.

NOTE:

The power and grounding terminals in this section are for illustration only.

The power input end of the switch has a noise filter, whose central ground is directly connected to the

chassis to form the chassis ground (commonly known as PGND). You must securely connect this chassis

ground to the earth so the faradism and leakage electricity can be safely released to the earth to

minimize EMI susceptibility of the switch.
You can ground the switch in one of the following ways, depending on the grounding conditions

available at the installation site:

Grounding the switch with a grounding strip

Grounding the switch through the PE wire of an AC power cord

Grounding the switch with a grounding strip

1.

Attach the two-hole grounding lug at one end of the grounding cable to a grounding point on the
switch chassis (see "

Connecting the grounding cable to the switch chassis

").

2.

Connect the OT terminal at the other end of the grounding cable to a grounding post on the
grounding strip, and fasten the grounding cable to the grounding post with a hex nut.

Figure 25 Connecting the grounding cable to a grounding strip

(1) Hex nut

(2) OT terminal

(3) Grounding post

(4) Grounding strip

20