H3C Technologies H3C S12500-X Series Switches - Manual (Page 76)

68
9. Install a new power module. For information about the installation procedures, see "Installing
FRUs."
10. Install the plastic panel. For more information, see "Installing the switch."
Figure 50 Removing the power module from the S12510-X AC
(1) Push the latch outward (2) Open the power module panel
(3) Pull the power module out (4) Close the power module panel
Replacing a card
WARNING!
When replacing a card while the switch is running, be aware of electrical safety hazards.
The replacement procedures of the cards on the S12500-X switches are similar. Before you replace a
card, remove all its cables.
If no new card is to be installed, install a blank filler panel to ensure adequate ventilation and dust
prevention.
1
3 4
2