H3C Technologies H3C S12500-X Series Switches - Manual (Page 105)

97
LPU model Description Connector Port
quantity Port speed
Available
transceiver modules
LSXM1QGS12FX
1
12-port 40-Gigabit
QSFP+ fiber
Ethernet interface
card
• MPO
• LC
12 40 Gbps
• QSFP+ module
• QSFP+ DAC cable
• QSFP+ to SFP+
DAC cable
LSXM1CGX8FX1
8-port 100-Gigabit
CXP fiber Ethernet
interface card MPO 8 100 Gbps CXP module
LSXM1CGP8FX1
8-port 100-Gigabit
CFP2 fiber Ethernet
interface card
LC 8 100 Gbps CFP2 module
LSXM1TGT48FX1
48-port 10-Gigabit
copper Ethernet
interface card
RJ-45 48 10/1 Gbps N/A
LSXM1GT48FX1
48-port
10/100/1000Ba
se-T copper
Ethernet interface
card
RJ-45 48
10/100/10
00 Mbps
N/A
Switching fabric modules
You can install one to six switching fabric modules for the switch. The switching fabric modules on the
switch must be the same type.
Table 30 Switching fabric module ordering guide
Chassis model Available switching fabric module model
• S12510-X AC
• S12510-X DC
• LSX1FAB10A1
• LSX1FAB10B1
• S12516-X AC
• S12516-X DC
• LSX1FAB16B1
• LSX1FAB16S1
Power modules
CAUTION:
The power modules on a switch must be the same model.
The S12500-X switches use N + N (dual-line power supply) or N + 1 (one-line power supply) power
redundancy. You can install appropriate number of power modules according to the power supply mode
and system consumption. Make sure the total maximum output power of the ordered power modules is
greater than the system power consumption. H3C recommends that you reserve 20% of the maximum
output power.
Table 31 describes power modules available for the S12500-X switches.