H3C Technologies H3C S12500-X Series Switches - Manual (Page 63)

55
Figure 45 Setting terminal emulation in Switch Properties dialog box
Powering on the switch
Before powering on the switch, confirm the following:
• You know where the emergency power-off switch for the equipment room is located.
• The switch has been securely mounted.
• All the cards have been correctly installed.
• The unused slots have been installed with filler panels.
• All the network cables, fibers, power cords, and grounding cables have been correctly connected.
• The input power voltage meets the requirement of the switch.
• The console cable is correctly connected, the terminal or PC used for configuration has started, and
the configuration parameters have been set.
To power on the switch, turn on the power source of the switch.
The following is a sample output you can see on the terminal:
System is starting...
Booting Normal Extend BootWare....
The Extend BootWare is self-decompressing.........Done.
****************************************************************************
* *
* BootWare, Version 1.06 *