ARAG Navigator LT - Manual (Page 7)

7
7 SETUP
7.1 Setup preparation
Before computer setup, check:
• that all components are correctly installed;
• the correct connection to the power source;
• the component connection.
Failure to correctly connect system components or to use specified components might damage the device or its components.
7.2 Switching on
Fig. 9
SOFTWARE VERSION
Fig. 10
Keep key pressed until Navigator
displays the screen shown in Fig. 9.
The software version is shown
immediately afterwards (Fig. 10).
FIRST DEVICE SWITCHING ON

Fig. 11 Fig. 12
Upon first switching on, after the
software version, Navigator displays
the "Home" screen (Fig. 11): press
F8 and enter the device basic
settings (chap. 9).
ORDINARY SWITCHING ON

 
Fig. 13
Fig. 14
After the software version, Navigator
displays the Select User prompt
(Fig. 13).
Press
F7 or F8 to move across
the available items, then press OK
to confirm your selection.
At this point, Navigator displays the
"Home" screen (Fig. 14).
SETUP
Par.
7.4
Exit the function
or data change Confirm access
or data change
Scroll
(LEFT /
RIGHT) Delete
selected
character Data
increase /
decrease Scroll
(UP /
DOWN) Enter
selected
character