ARAG Navigator LT - Manual (Page 41)

41
12.4.2 SD card
It allows transferring the saved data (Fig. 146) from the SD card onto the internal memory of Navigator.
The following paragraphs will use
Implements as an example: the same procedure will be valid for all other cases ( Tractors , Users , etc., Fig. 146).

1
1 Press F4 to enter Memories management .
2 Select the SD card menu and press OK .
3 Select Implements (Fig. 146) and press OK .
4 In the list of memorized names select the desired implement (Fig. 147) and press OK .
A list of actions that can be performed for the selected implement will appear ( Delete etc., Fig. 147). These will be described below.
The option [Select all... ] allows performing the same operation simultaneously on ALL implements of the list,
EXCEPT THE ACTIVE ONE.

2
Fig. 145

3
Fig. 146

4
Fig. 147
• Delete

Fig. 148

Fig. 149
Allows to delete data from the SD card.
- Select Delete (Fig. 148) and press OK .
- The message in Fig. 149 is displayed: confirm
deletion by pressing
OK again.
• Copy onto internal memory

Fig. 150
Allows to copy data from the SD card onto Navigator internal memory.
- Select the item
Copy to internal memory (Fig. 150) and press OK .
ERROR MESSAGES
Fig. 151
ERROR 1: a file with the same name already exists on the
internal memory.
ERROR 2: a file with the same name already exists on the
internal memory and it is being used.
- Press OK to replace the file (all data in the replaced file
will be lost).
- Press
ESC to avoid replacing the file (check its contents or
edit its name before trying to save again).
Fig. 152
"HOME" MENU - F4 MEMORIES MANAGEMENT > SD CARD