AEC HE Mass Flow Series Drying hoppers - Manual (Page 46)

HE
• CHE • BCHE Mass Flow Series Drying Hoppers
Page 45
Figure 16
Default Setting List for 1/16 DIN Process Temperature Controller
Mode Parameter Setting range Default AEC setting
Setup Cn-E Input Type 0 to 21 2 3
Setup Cn-H Scaling Upper Limit Scaling Lower Limit +1 to 9999 EU -100 Default
Setup Cn-L Scaling Lower Limit
-1999 to SP Setting Upper Limit -
0.1 EU
0 Default
Setup dP Decimal Point 0 to 3 0 Default
Setup d-U °C/F Selection °C/F °C °F c
Setup CnCE Parameter Initialize Yes/No No Default
Setup
6UE1 Control Output 1
Assignment
Heat/Cool/Alarm 1/ Alarm 2/Alarm
3/LBA
Heat Default
Setup
6UE2 Control Output 2
Assignment
Heat/Cool/Alarm 1/ Alarm 2/Alarm
3/LBA
AL-1 Default
Setup
Sub 1 Auxiliary Output 1
Assignment
Alarm 1/Alm 2/Alm 3/LBA/S.
ERR/E333
AL-2 Default
Setup ALE1 Alarm 1 Type 0 to 11 2 Default
Setup
AL1n Alarm 1 open in
alarm
NO/NC NO Default
Setup ALE2 Alarm 2 Type 0 to 11 2 Default
Setup
AL2n Alarm 2 open in
alarm
NO/NC NO Default
Setup ALE3 Alarm 3 Type 0 to 11 2 Default
Setup
AL3n Alarm 3 open in
alarm
NO/NC NO Default
Setup
6rEu Direct/Reverse
Operation
OR-R/OR-D OR-R Default
c Check sales order for temperature unit selection.
Mode Parameter Setting range Default AEC setting
Expansion SL-H Set Point Upper Limit
SP Lower Limit +1 to
Scaling Upper Limit
1300 400.0
Expansion SL-L Set Point Lower Limit
Scaling Upper Limit to SP
Lower Limit
-200 0
Expansion CnEL PID/ON/OFF PID/ON/OFF PID Default
Expansion SE ST Adaptive Tuning (Fuzzy) OFF/ON OFF Default
Expansion SE-b ST Stable Range 0.1 to 999.9 °C/F 15 Default
Expansion ALFA
α
0.01 to 1.00 0.65 Default
Expansion AE-G AT Calculated Gain 0.1 to 10.0 1.0 Default
Expansion
rESE Standby Sequence Reset
Setting Method
0/1 0 Default
Expansion
rEE Automatic Return of
Display Mode
0 to 99 SEC 0 Default
Expansion AE-H AT Hysteresis 0.1 to 9.9 %FS 0.2 Default
Expansion LbAb LBA Detection Width 0.0 to 999.9 %FS 0.2 Default