AEC HE Mass Flow Series Drying hoppers - Manual (Page 44)

HE
• CHE • BCHE Mass Flow Series Drying Hoppers
Page 43
Entering Operating Parameters to Select Modes for 1/16 DIN
Controllers
To enter the menu display:
1. Press for one second (keep the pressure on the button for about 1.5 to 2 seconds).
The screen displays .
2. Press the Up Arrow key to toggle through the different modes.
The SV readout displays the mode you selected.
3. To switch parameters within a mode, press the Display key once more for about
one and a half to two (1.5 to 2) seconds.
The PV readout displays the different parameters within each mode.
4. Use short presses on the Display key to display each parameter within a mode.
The SV readout displays the different values for the parameter within a mode.
5. Press and to set the higher or lower the values of a parameter.
6. Press for about one and a half to two (1.5 to 2) seconds to move up a level back
into the different modes.
7. Press until Level 0 displays.
8. Press for about one to one and a half (1 to 1.5) seconds to go to Operating mode.
Figure 16
Default Setting List for 1/16 DIN Process Temperature Controller
Mode Parameter Setting range Default AEC setting
Protect SECr Security 0 to 6 1 5
Protect YEYP A/M Key Protect ON/OFF OFF ON
Manual Manual MV -5.0 to 105.0% 0.0 Default