3 using temperature controller internal switches – AEC HE Mass Flow Series Drying hoppers User Manual

Page 29

Page 28

• CHE • BCHE Mass Flow Series Drying Hoppers

Mode Button

Press the

Mode button to scroll through parameters you can set in Indication Levels 0

and 1.

Note: During normal operation, press this button to change the alarm setting only. The factory

alarm setting is 25º above the set point, and is satisfactory for most applications.

Down Button

Press the

Down

button to lower the process air set point temperature. During setup, press

this button to decrease the value of the parameter displayed in the

(Set Value) LED screen.

Up Button

Press the

button to raise the process air set point temperature. During setup, press this

button to increase the value of the parameter displayed in the

(Set Value) LED screen.

AT (Auto-Tune) Button

Press and hold the

(Auto-Tune) button for one second or more to start the Auto-Tune

function. See Section 5-8 on Page 30 for more information.

5-3 Using Temperature Controller Internal Switches

The control is set up and tested at the factory for optimum operation, and the internal switches
don’t need to be adjusted. If the controller does not work properly, or you suspect someone has
inadvertently changed some settings, perform the Auto-Tune procedure as listed in Section 5-8
on Page 30. If that doesn’t work, see Section 5-9 on Page 31 for information on returning the
controller to factory setup.

This manual is related to the following products:

CHE Mass Flow Series Drying hoppers BCHE Mass Flow Series Drying hoppers