Step 3: install the bracket, Installation guide – ACTi Bullet Camera on Straight Wall with Bundled Bracket User Manual
Page 19
Installation Guide
5.
Tighten the sealing nut.
NOTES on using Ethernet cables:
When replacing the pre-installed network cable, it is
recommended to use
exterior-grade
Ethernet cables (CAT5/CAT5e/CAT6); ordinary Ethernet
cables are only designed for indoor use and may deteriorate quickly when exposed to
outdoor elements. Exterior-grade Ethernet cables are waterproof and do not require a
conduit.
Step 3: Install the Bracket
1.
Mark the location of the three (3) screw holes using the bracket plate included in the
package.
NOTE:
Depending on the surface where you will install the camera, it may be necessary to
drill the holes and use the supplied screw plugs.
This manual is related to the following products:
- Bullet Camera on Straight Wall with Heavy Duty Bracket Bullet Camera on Tilted Wall with Bundled Bracket Bullet Camera on Hard Ceiling with Bundled Bracket Bullet Camera on Dropped Ceiling with Bundled Bracket Bullet Camera on Corner with Accessory Set Bullet Camera on Vertical Pole with Accessory Set