Step 1: remove the pre, Installed network cable (“pigtail”), Installation guide – ACTi Bullet Camera on Straight Wall with Bundled Bracket User Manual
Page 17
Installation Guide
Step 1: Remove the Pre-installe
d Network Cable (“Pigtail”)
1.
Loosen the three (3) screws to detach the back cover.
NOTE:
A cable is connected inside the camera; do not abruptly pull the back cover.
2.
Disconnect the network connector (A) and remove the sealing nut (B).
3.
Pull out the network cable from the back cover and disassemble the parts as marked below.
4.
Squeeze the seal to pull out the connector and then completely remove the seal, claw, and
sealing nut from the network cable.
Sealing Nut
Claw
Seal
(A)
(B)
This manual is related to the following products:
- Bullet Camera on Straight Wall with Heavy Duty Bracket Bullet Camera on Tilted Wall with Bundled Bracket Bullet Camera on Hard Ceiling with Bundled Bracket Bullet Camera on Dropped Ceiling with Bundled Bracket Bullet Camera on Corner with Accessory Set Bullet Camera on Vertical Pole with Accessory Set