Step 2: install the new ethernet cable, Installation guide, 18 step 2: install the new ethernet cable – ACTi Bullet Camera on Straight Wall with Bundled Bracket User Manual
Page 18
Installation Guide
Step 2: Install the New Ethernet Cable
1.
Insert the new Ethernet cable through the sealing nut, claw, seal, and cable gland of the back
cover.
2.
Attach the RJ-45 connector to the Ethernet cable. See
page 54.
3.
Assemble the seal and claw, and then connect the RJ-45 connector to the Ethernet port
inside the camera.
4.
Attach the back cover by tightening the three (3) screws.
2
2
1
2
This manual is related to the following products:
- Bullet Camera on Straight Wall with Heavy Duty Bracket Bullet Camera on Tilted Wall with Bundled Bracket Bullet Camera on Hard Ceiling with Bundled Bracket Bullet Camera on Dropped Ceiling with Bundled Bracket Bullet Camera on Corner with Accessory Set Bullet Camera on Vertical Pole with Accessory Set