Step 1: install the bracket – ACTi Bullet Camera on Straight Wall with Bundled Bracket User Manual
Page 23
Installation Guide
Installation Using the Heavy Duty Bracket and Sealant
Tape
Step 1: Install the Bracket
1.
Remove the screw to detach the camera holder from the bracket.
2.
Mark the location of the three (3) screw holes using the bracket and attach the bracket to the
wall using the supplied screws.
NOTE:
Depending on the surface where you will install the camera, it may be necessary to
drill the holes and use the supplied screw plugs.
3.
Align the screw holes of the holder to the bottom screw holes of the camera.
This manual is related to the following products:
- Bullet Camera on Straight Wall with Heavy Duty Bracket Bullet Camera on Tilted Wall with Bundled Bracket Bullet Camera on Hard Ceiling with Bundled Bracket Bullet Camera on Dropped Ceiling with Bundled Bracket Bullet Camera on Corner with Accessory Set Bullet Camera on Vertical Pole with Accessory Set