Step 1: remove the pre, Installed network cable (“pigtail”) – ACTi Bullet Camera on Straight Wall with Bundled Bracket User Manual
Page 10
Installation Guide
Step 1: Remove the Pre-
installed Network Cable (“Pigtail”)
1.
Loosen the three (3) screws to detach the back cover.
NOTE:
A cable is connected inside the camera; do not abruptly pull the back cover.
2.
Disconnect the network connector.
3.
Remove the pre-installed cable gland and network cable using pliers (not included in the
package).
This manual is related to the following products:
- Bullet Camera on Straight Wall with Heavy Duty Bracket Bullet Camera on Tilted Wall with Bundled Bracket Bullet Camera on Hard Ceiling with Bundled Bracket Bullet Camera on Dropped Ceiling with Bundled Bracket Bullet Camera on Corner with Accessory Set Bullet Camera on Vertical Pole with Accessory Set