ACTi Bullet Camera on Straight Wall with Bundled Bracket User Manual
Page 16
Installation Guide
Installation Using the Bundled Bracket and Naked Cable
The pre-installed network cable comes with an Ethernet port (female connector), or known as a
“pigtail”. The length of the cable is around 14 ~ 35 cm (varies by model). The network cable and
gland are resistant to salt water, weak acid, alcohol, oil, grease and common solvents.
In case the installation environment requires a change of this network cable, such as the use of
an Ethernet cable with male connector, it is recommended to use
exterior-grade
Ethernet cables
(CAT5/CAT5e/CAT6); ordinary Ethernet cables are only designed for indoor use and may
deteriorate quickly when exposed to outdoor elements. Exterior-grade Ethernet cables are
waterproof and do not require a conduit.
To replace the pre-installed network cable, follow the step-by-step procedures in this section and
prepare the following:
Screwdriver
Ethernet cable without connectors
RJ-45 Connector (x2)
RJ45 Crimping Tool
Pliers
NOTE:
The above materials/tools are not included in the package.
14 cm ~ 35 cm
- Bullet Camera on Straight Wall with Heavy Duty Bracket Bullet Camera on Tilted Wall with Bundled Bracket Bullet Camera on Hard Ceiling with Bundled Bracket Bullet Camera on Dropped Ceiling with Bundled Bracket Bullet Camera on Corner with Accessory Set Bullet Camera on Vertical Pole with Accessory Set