Westermo MDI-112-F4G - Manual (Page 88)

84
4.5.5 CLI Commands of the VLAN
Command Lines of the VLAN port configuration, VLAN configuration and VLAN
table display
Feature Command Line
VLAN Port Configuration
VLAN Port PVID Switch(config-if)# switchport trunk native vlan 2
Set port default vlan id to 2 success
Port Accept Frame
Type
Switch(config)# inter fa1
Switch(config-if)# acceptable frame type all
any kind of frame type is accepted!
Switch(config-if)# acceptable frame type
vlantaggedonly
only vlan-tag frame is accepted!
Ingress Filtering
(for fast Ethernet
port 1)
Switch(config)# interface fa1
Switch(config-if)# ingress filtering enable
ingress filtering enable
Switch(config-if)# ingress filtering disable
ingress filtering disable
Egress rule –
Untagged (for VLAN 2)
Switch(config-if)# switchport access vlan 2
switchport access vlan - success
Egress rule – Tagged
(for VLAN 2)
Switch(config-if)# switchport trunk allowed vlan
add 2
Display – Port
Ingress Rule (PVID,
Ingress Filtering,
Acceptable Frame
Type)
Switch# show interface fa1
Interface fastethernet1
Administrative Status : Enable
Operating Status : Not Connected
Duplex : Auto
Speed : Auto
Flow Control :off
Default Port VLAN ID: 2
Ingress Filtering : Disabled
Acceptable Frame Type : All
Port Security : Disabled
Auto Negotiation : Enable
Loopback Mode : None
STP Status: disabled
Default CoS Value for untagged packets is 0.