Westermo MDI-112-F4G User Manual
Page 145
141
Multicast will appear after you enabled IGMP and the switch learnt IGMP report.
Click on Remove to remove the static Unicast/Multicast MAC address. Click on
Reload to refresh the table. New learnt Unicast/Multicast MAC address will be
updated to MAC address table.
4.12.2 Port Statistics
In this page, you can view operation statistics for each port. The statistics that
can be viewed include Link Type, Link State, Rx Good, Rx Bad, Rx Abort, Tx Good,
Tx Bad and Collision. Rx means the received packet while Tx means the
transmitted packets.
Note: If you see many Bad, Abort or Collision counts increased, that may mean
your network cable is not connected well, the network performance of the port is
poor…etc. Please check your network cable, Network Interface Card of the
connected device, the network application, or reallocate the network traffic…etc.
Click on Clear Selected to reinitialize the counts of the selected ports, and Clear
All to reinitialize the counts of all ports. Click on Reload to refresh the counts.